In daily life, push table saw machine is widely used for cutting, however, some people complain that there are some problems during the cutting process and maintenance, what’s more, they don’t know how to solve these problems. In this article below, I will introduce some common using problems and their solution, are you interested in such topic?

Firstly, if there is bad edge broken condition at the top of push table saw machine, here are the reasons for such trouble.

The main saw blade is too much blunt, at the same time, the number of saw teeth is limited.

The height of main saw blade is not higher enough than the cutting panel raw materials.

The panel raw materials are the poor quality ones, which is not suitable for cutting with saw blade at such condition.

After learning these three possible reasons, here are the corresponding solution you can take a try, change the main saw blade with sharp saw teeth, or rise main saw blade for cutting, or pay attention on the panel cutting material’s quality, and it is better to choose top quality panel with less impurities.

Secondly, if there is burning phenomenon on panel after being cutting. Under such circumstance, pay attention on these two reasons, the first one would be that saw blade is too much blunt, and on it there are too many saw teeth, the other reason would be too fast revolving speed or too low cutting feed speed.

Obviously, you can solve such problem with these solutions, change saw blade with suitable saw teeth number, or reduce saw blade revolving speed or increase its feeding speed.

Thirdly, when cutting, some parts on raw materials are jacked up with assistant saw blade. If such bad problem is happened, take it easy, you can easily solve it, for example, you can change the suitable saw blade, or reduce the assistant saw blade’s height properly.

Finally, if there is edge broken condition on panel material after being cutting. Here are three possible reasons that the assistant saw blade is too blunt, or the width of assistant saw blade is not enough, or the center line of main saw blade and assistant saw blade is not coincident.

OK, try these solutions and I am sure it would be useful, change the suitable saw blade, or increase the thickness of saw blade, or adjust the location of assistant saw blade so as to make the center line be coincident.