In the following article, I will introduce two common problems when using circular saw blade for cutting, are you interested in learning these knowledge?

Firstly, saw blade is not round shape any longer. As for reasons of such condition, because of abrasion on principal axis, the gap between saw blade center hole and principal axis would be more and more larger, or sometimes its installation is not very right.

If you know the reason of such condition, it is easy to solve, for example, you can change the abraded axle or repair center holes.

Secondly, saw blade will shake from right to left, or from left to right. When the cutting material crumbs are clamped tightly inside, there would be different stress on matrix, which finally leads to such shake. Meanwhile, if the diameter of ring flange is too small or both sides of ring flange are not the same, such problem would be also resulted. Of course, if there are some impurities between saw blade and ring flange or saw blade is not installed rightly, such problem can not be avoided.

In order to solve such problem, three tips you can follow, for example, clean cutting crumbs and enhance crumbs discharge function, adjust or change ring flange, install saw blad with right ways.